Science Forums 2

[belovelife]

i know for efficient transfer of liquid oxygen to gas
it is more efficient to use a coil of tubing, for my purpose we get more efficiency
in gas form than liquid because you have more efficient combustion and less waste oxygen
the liquid form has too high of a concentration of oxygen vs fuel

now in theory, atmoshere could be condensed to a liquid, but all the gasses are liquid at different
pressure and temp (STP)
and if you compress atmoshere in any form you get water
which if you use a compressor in any job you know you have to bleed the water out of the
tanks

but you could use the transfer of heat from the friction of the pnumatic motor to give a little extra
force to the compressed air right

anyway this is getting way off topic

but do you think if you had a pnumatic tool
and you took it apart
that you could fabricate the inner parts to closer tolerances
so you could use the same block, just machine it to have more accurate tolerances?